ShiftX3 – a sequential shift light + 7 segment gear indicator
ShiftX3 is the ultimate accessory – use it as a shift light, set up alerts, or visualize predictive lap times.
Fully customizable RGB sequential display and alerts for your RaceCapture system
ShiftX3 has 9 super-bright RGB LEDs in a compact, surface-mountable package, with plug and play wiring.
- RaceCapture/Pro MK2/MK3
- RaceCapture/Track MK2
Not compatible with RaceCapture/Track MK1
Ultra bright, daylight-visible 7 segment display to show current gear or other data
You can setup ShiftX3 to show your current gear, or have it show any RaceCapture channel value you’d like.
Use it as a sequential shift light and never miss a shift
Set up a shift light to show any color, with up to 5 RPM thresholds – even customize it to flash.
Use it to visualize your predictive lap times and shave seconds off your best
Use the center gauge to visualize your current lap time performance against the session’s best time. Green bar means you’re beating the best lap.
Use it for sensor alerts and save your engine
The two flanking LEDs can be individually controlled to light up at sensor thresholds. Up to 5 trigger thresholds can select any color and variable flash rate.
Use it to visualize sensor values
Use the center graph to visualize data from sensors you already have connected to your RaceCapture/Pro system. Visualize Air/Fuel Ratio, Boost level, Engine or Oil Temperature – it’s fully configurable.
Left and right navigation hard buttons to switch dashboard screens in the RaceCapture app
ShiftX3 includes navigation buttons that will scroll your RaceCapture dashboard screen left and right – perfect for gloved operation.
Auto-dimming for night-time racing
An on-board photosensor will auto-dim the display, a necessity for nighttime racing.
Easy to install and set up
With the CAN bus installation kit, it’s easy to wire up for OBDII vehicles, and just power and ground for all other installations. Check out our Wiki for full installation guide.
What’s in the kit
Every ShiftX3 includes:
- mounting screws
Optional CAN hub accessory kit
Choose the CAN hub accessory kit which makes OBDII installations plug and play with RaceCapture/Track MK2 and RaceCapture/Pro. For RaceCapture/Apex, choose the standard package – wiring is easy with just power, ground and 2 wires for CAN bus.
Installation / Setup Guide
- Dimensions 145 x 32 x 9.2mm (5.7 x 1.25 x 0.366 inches)
- Weight: 70g (0.154 lbs)
- Voltage supply: 9-12v
- Current requirement: 500mA(Max)
- CAN baud rate: 500K or 1MB (selectable)